Contents

- 1 How do I calculate motor cable size?
- 2 What is the formula to calculate wire size?
- 3 How many amps can a 4mm cable take?
- 4 How do you determine AWG wire size?
- 5 What size wire do I need for a 200 amp service?
- 6 What wire is needed for 220v 30 amp?
- 7 What size wire is good for 60 amps?
- 8 What is the color code for 3 phase wiring?
- 9 What wire do you use for 3 phase?
- 10 What size breaker do I need for a 5 hp motor?

## How do I calculate motor cable size?

Size of Cable for Branch circuit which has Single Motor connection is 125% of Motor Full Load Current Capacity. Example: what is the minimum rating in amperes for Cables supplying 1 No of 5 hp, 415-volt, 3-phase motor at 0.8 Power Factor. Full-load currents for 5 hp = 7Amp. Min Capacity of Cable= (7X125%) =8.75 Amp.

## What is the formula to calculate wire size?

Divide the voltage running through the cable by your target current. If, for instance, 120 volts will act on the cable, and you want 30 amps to run through it: 120 / 30 = 4. This is your target resistance, measured in ohms. 30,000 x 1.724 x 10^-8 = 0.0005172 ohm sq.

## How many amps can a 4mm cable take?

4mm clipped direct has a current rating of 37 Amps, all other installation methods drop that rating down to 32 Amps.

## How do you determine AWG wire size?

AWG: In the American Wire Gauge (AWG) system, wire size diameters can be calculated by applying the formula D(AWG)=. 005ยท92^{((}^{36}^{–}^{AWG}^{)/}^{39}^{)} inch. For the 00, 000, 0000 etc.

## What size wire do I need for a 200 amp service?

Wire Sizes For 200 Amp Service Wiring 200 amp service requires either #2/0 copper wiring or #4/0 aluminum or aluminum clad wiring. Which wire used is determined by the voltage drop and length of the wiring. Many electrical contractors opt to use #4/0 aluminum or copper-clad wire.

## What wire is needed for 220v 30 amp?

Any circuit fused for 30 amps must use a minimum of 10 ga copper or 8 ga alu. Longer runs may require an upgrade of wire size. In your case, use at least 10 copper for your welder regardless how far it is from the breaker panel.

## What size wire is good for 60 amps?

For 60 ampere breakers, electricians and professionals suggest using a wire size gauge ranging from 6 AWG to 4 AWG. All household wires have a rating of at least 600V, so only amperage really matters when it comes to determining wire gauge.

## What is the color code for 3 phase wiring?

Phase 3 – Phase 3 wiring should be yellow. Neutral – Neutral wires should be grey. Ground – Ground wiring should be green, or green with a yellow stripe.

## What wire do you use for 3 phase?

The three hot wires in a three-phase circuit are colored black, blue and red; a white wire is the neutral and a green wire is used for the ground.

## What size breaker do I need for a 5 hp motor?

A 5hp single phase AC motor has a load current of 28 Amps. So 10GA. wire with a 30 Amp breaker will work.